Audio Note M2 Line Pre-amplifier with Phono and Audio Note Conquest 300b Monoblock Tube Power Amplifier

Audio Note M2 Line Pre-amplifier with Phono and Audio Note Conquest 300b Monoblock Tube Power Amplifier

M2 Line Pre-amplifier selling for RM9500
Conquest 300b Monoblock Tube Power Amplifier selling for RM23800
Take the whole set for RM32000

Contact Peter 012-3820333
Whatsapp me https://wa.me/message/DPSIPO7MHBUPA1


Audio Note M2 Line/Phono Pre-amplifier
In good condition 8/10
Unit is Line model and has been upgraded with Phono as seen in the pictures.

The Audio Note (UK) M2 Pre Amplifier has been specifically engineered for sonic performance rather than technical specification, and fulfils all Audio Note (UK) Level 2 criteria: -

Pure Class A operation
Zero negative feedback
Single Ended circuit topology
Valve rectification
Materials and component quality

It is well known that the accurate reproduction of music, not just sound, requires the purity of the incoming signal to be preserved. It is therefore not difficult to conclude that, in order to achieve this goal and to retain the musicality of the original performance, the complexity of the circuitry itself must be kept to a minimum. In response to this, the M2 Pre Amplifier uses a single-ended, zero feedback circuit topology. This is simply the most linear design possible, demanding pure Class A valve operation and removing the need for a phase splitter, which introduces unnecessary crossover distortion.

The M2 was designed for maximum linearity and minimum transient distortion, and avoids the need for detrimental "corrective" measures, such as inherently error-prone feedback loops.

The M2 Phono Pre Amplifier features a 6SN7 line stage, an ECC83 and 6DJ8 Moving Magnet phono stage, and a valve-rectified power supply incorporating a 6X5 and an ECL82.

Specifications
Technical Specifications
INPUT IMPEDANCE : 100K Ohms - Line Level
                                : 47K Ohms - Phono
INPUT SENSITIVITY : 126mV for 1V Output
OUTPUT IMPEDANCE : <10 Ohms
UNIT WEIGHT : 7 kg
UNIT DIMENSIONS : 140mm (h) x 295mm (w) x 450mm (d)
MAINS INPUT : AC 220-240V 50/60Hz


Audio Note Conquest Monoblock Tube Power Amplifier
Parallel Single Ended 300B Monoblock

The conquest is a pair of mono power amplifiers, that is 18 watts per channel.
They are pure Class A Parallel Singled Ended valve amplifiers that use a pair of the highly regarded 300B triode valves per channel.
It is suitable for less efficient loudspeakers because of its higher output levels but still gives its best with high efficiency loudspeakers.
Used in combination with a suitable Audio Note pre-amplifier, results are breath taking.
The tube sockets have been upgraded

Pure Class A operation
Zero Negative Feedback
Single Ended Output Stage
Valve Rectification
Directly Heated Triode operation
Materials and component quality

Specifications
INPUT IMPEDANCE : 100K Ohm
INPUT SENSITIVITY : 250mV / 3.15V (Low Gain) for full output
MAXIMUM OUTPUT : 18 Watts RMS  per channel into 4 or 8 Ohm loads
CHANNEL BALANCE : +/- 0.3dB
VALVE COMPLEMENT : 2 x 5U4GB (1 per chassis)
                                     4 x 300B (2 per chassis)
                                     2 x 6SN7 / 6J5 Metal (Low Gain) (1 per chassis)
UNIT WEIGHT : 20kg (per amplifier)
UNIT DIMENSIONS : 195mm (h) x 205mm (w) x 500mm (d) (per amplifier)