Emotiva XPA-100 Monoblock - sold
Hi-Fi 4 Sale - Malaysia / Singapore Audio Forum & Marketplace | www.hifi4sale.net :: Audio & Video Equipment Marketplace :: Audio & Video Equipment: FOR SALE (Pre-owned & Used)
Page 1 of 1
Emotiva XPA-100 Monoblock - sold
Emotiva XPA-100
Topology: Fully discrete, dual differential, high current, short signal path Class A/B.
Number of Channels: 1
Power Output (rated power; THD < 1%):
250 watts (1 channel) into 8 Ohms. 400 watts (1 channel) into 4 Ohms.
Rated Power Bandwidth (at rated power; 8 Ohm load):
10 Hz to 20 kHz + / - 0.07 dB.
Minimum Recommended Load Impedance: 4 Ohms (which equals one 4 Ohm load or two paralleled 8 Ohm loads).
Frequency Response: 10 Hz to 80 kHz (+ 0 / - 1 dB).
THD + noise: < 0.02%
Signal to Noise Ratio (8 Ohm load): > 89 dB at 1 watt (A-weighted).
> 112 dB at rated power (A-weighted).
Damping Factor (8 Ohm load): > 500
Speaker Output Connections: Full-sized, 5-way binding posts; two pairs per channel (one channel).
Input Sensitivity (for rated power; 8 Ohm load): 1200 mV.
Gain: 29 dB.
Input Connections: Unbalanced (RCA); balanced (XLR); one each.
Input Impedance: 47 kOhms.
Trigger: Trigger Input: 5 - 20 V (AC or DC); <10 mA input current required. Trigger Output: 12 VDC; can drive any load up to 50 mA.
Power Requirements: 115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (automatically detected and switched).
Front Panel Controls and Indicators: Standby; push button (halo ring changes color to indicate Standby or On).
Status LEDs (two); blue LED illuminates for normal operation, red LED ashes during power-on or when a fault occurs; (may be disabled by rear panel Status LED switch).
Rear Panel Controls: AC Power switch; rocker switch (switches AC mains power).
Status LEDs switch; small slide switch on left (disables front panel Status LEDs and dims. Standby button halo lighting).
Input selector; toggle switch (selects between balanced and unbalanced inputs).
Protection: The XPA-100 is protected against excessive operating temperature, shorted speaker connections, ground faults, and other common fault conditions.
Dimensions: 17” wide x 3.875” high x 19” deep
Condition: 8/10, with good exterior and perfect working condition.
Price: sold to a nice gentleman. Thanks.
Contact: 012 408 5100
May test and collect at Subang Jaya.
Topology: Fully discrete, dual differential, high current, short signal path Class A/B.
Number of Channels: 1
Power Output (rated power; THD < 1%):
250 watts (1 channel) into 8 Ohms. 400 watts (1 channel) into 4 Ohms.
Rated Power Bandwidth (at rated power; 8 Ohm load):
10 Hz to 20 kHz + / - 0.07 dB.
Minimum Recommended Load Impedance: 4 Ohms (which equals one 4 Ohm load or two paralleled 8 Ohm loads).
Frequency Response: 10 Hz to 80 kHz (+ 0 / - 1 dB).
THD + noise: < 0.02%
Signal to Noise Ratio (8 Ohm load): > 89 dB at 1 watt (A-weighted).
> 112 dB at rated power (A-weighted).
Damping Factor (8 Ohm load): > 500
Speaker Output Connections: Full-sized, 5-way binding posts; two pairs per channel (one channel).
Input Sensitivity (for rated power; 8 Ohm load): 1200 mV.
Gain: 29 dB.
Input Connections: Unbalanced (RCA); balanced (XLR); one each.
Input Impedance: 47 kOhms.
Trigger: Trigger Input: 5 - 20 V (AC or DC); <10 mA input current required. Trigger Output: 12 VDC; can drive any load up to 50 mA.
Power Requirements: 115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (automatically detected and switched).
Front Panel Controls and Indicators: Standby; push button (halo ring changes color to indicate Standby or On).
Status LEDs (two); blue LED illuminates for normal operation, red LED ashes during power-on or when a fault occurs; (may be disabled by rear panel Status LED switch).
Rear Panel Controls: AC Power switch; rocker switch (switches AC mains power).
Status LEDs switch; small slide switch on left (disables front panel Status LEDs and dims. Standby button halo lighting).
Input selector; toggle switch (selects between balanced and unbalanced inputs).
Protection: The XPA-100 is protected against excessive operating temperature, shorted speaker connections, ground faults, and other common fault conditions.
Dimensions: 17” wide x 3.875” high x 19” deep
Condition: 8/10, with good exterior and perfect working condition.
Price: sold to a nice gentleman. Thanks.
Contact: 012 408 5100
May test and collect at Subang Jaya.
emanon- New Member
- Number of posts : 5
Age : 51
Location : KL
Registration date : 2009-09-16
Similar topics
» >>>> Emotiva 2x XPA-1 monoblock amps [SOLD]
» Emotiva XPA-100 Monoblock Power Amplifier [SOLD]
» Emotiva UPA-1 Monoblock Power Amplifier (200 Watt) [SOLD]
» Emotiva XPA-100 Monoblock Amplifier
» Emotiva XPA-1L Class A/Class AB Monoblock Amplifier [SOLD]
» Emotiva XPA-100 Monoblock Power Amplifier [SOLD]
» Emotiva UPA-1 Monoblock Power Amplifier (200 Watt) [SOLD]
» Emotiva XPA-100 Monoblock Amplifier
» Emotiva XPA-1L Class A/Class AB Monoblock Amplifier [SOLD]
Hi-Fi 4 Sale - Malaysia / Singapore Audio Forum & Marketplace | www.hifi4sale.net :: Audio & Video Equipment Marketplace :: Audio & Video Equipment: FOR SALE (Pre-owned & Used)
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum