Elekit TU8200 Tube Amp with additional upgrades (sold)

Elekit TU8200 Tube Amp with additional upgrades.
In very good condition

Asking for SOLD
Contact Peter 012-3820333

Tubes : 6L6GC x 2, 12BH7 x 2
Circuit automatically adjusts bias for the optimal operation of each tube
3 amplification modes (triode, pentode and ultra-linear) can be selected using PCB jumpers - Ultra linear (8W + 8W) / Triode (4W + 4W) / Pentode (8.2W + 8.2W)
FET ripple filter on board for power B for both left and right channels
Has overcurrent protection
High quality PCB with 70um copper traces (double regular thickness)
Audio Inputs : 2 x RCA and 1 x 3.5mm jack
Audio Outputs - Speaker impedance selector switch - 8-16Ω / 4-6.3Ω 
Headphone jack at front.

Parts upgrade done base on recommendation as per diy forum, 
https://www.diyaudio.com/forums/elekit/331769-elekit-tu-8200dx.html

Component(s)	Original Value	New Value	Comment
C22	180μF/400V	270-330μF/400V	Significantly less hum on headphone output. Max length = 36mm
C23,C24	10μF/400V	22μF/400V	More delay to B+ voltage, protecting tubes after switching on the amp. Max length = 36mm
C7,C8,C11,C12	10μF/400V	15μF/400V	Optional - gives a bit more room. Max length = 20mm
C31,C32	3300μF/10V	10000μF/10V	Higher and better filtered DC heater voltage. Max length = 36mm
R64	0.47 Ohm	Short (0 Ohm)	Cut off a pin of a resistor, bend it twice
D7	DB107	DB207	Lower forward voltage drop. Required for driver update.
C34,C35	220μF/16V	220μF/16V	Optional - gives better high frequency filtering of bias reference
C13,C14	220μF/16V	470μF/16V	The low ESR is very important
C33	220μF/16V	330-470μF/16V	Better low frequency filtering of bias reference

THIS IS LUNDALL TRANSFORMER OR NORMAL Ei

Only the upgraded 8200R models uses Lundall transformers

bump